Kicker VCVR122 12" Single CVR Sub Box

Nominal Impedance [Zn], 2 ohms [per enclosure]
Sensitivity [SPLo], dB @ 1W, 1m 95
Power Handling Watts, Peak (RMS) 800 (400)
Enclosure Top Surface Depth, in (cm) 11 9/16 (29.4)
Enclosure Bottom Surface Depth, in (cm) 14 13/16 (37.6)
Enclosure Height, in (cm) 16 (40.6)
Enclosure Width, in (cm) 17 1/2 (44.5)
The DCVR Series vented enclosures combine KICKER's award winning line of subwoofers with computer-modeled and human fine-tuned enclosures to offer a level of bass performance never before thought possible from a commercially available, ready-to-install subwoofer system. The DCVR Series enclosures are available with a pair of pre-loaded 10 or 12 inch CompVR subwoofers. The VCVR Series enclosure is available with a pre-loaded 12 or massive 15 inch CompVR.
The location and orientation of your enclosure will affect the quality and quantity of the bass. Designed
for use in SUV and sedan type vehicles, these enclosures offer you several mounting options. The vent
opening in these enclosures can not be obstructed. At some frequencies most of the bass will come
out of the vent. Therefore we recommend you leave at least four inches (10cm) of clear space around
the vent.
If the enclosure is to be mounted all the way in the back of the vehicle, it works best to point the
woofer toward the front of the vehicle. Conversely, if the enclosure is going to be mounted closer to the
back seat, pointing the woofer toward the rear of the vehicle will give you the best results. These
guidelines pertain to enclosures mounted in the vehicle as outlined in Figure 1.
If it is more convenient to mount the enclosure along a side wall, put the enclosure on the left side of
the vehicle as outlined in Figure 2. This orientation will make the vent point toward the rear of the
vehicle and will produce the most low bass output. Remember to leave at least four inches (10cm) of
room between the enclosure and the back of the vehicle.
After determining the best mounting position, carefully check the areas where the mounting brackets
will be placed. Make sure the mounting screws will not puncture the gas tank, brake lines, wiring, or
interfere with any mechanical parts on the underside of the mounting surface. Turn the enclosure
upside-down, pre-drill the holes using a 7/64" (2.5mm) bit and attach the four mounting brackets to the
UPC: 713034025887